Just thought I'd stop by.. I dont get on much these days and just realized how long its been since I was here last.

Since then I havent done all that much to my TA.

I did take it to work and when I wasnt busy, I put my 2" lowering Canuck Motorsports springs all the way around and I installed KYB struts and shocks and KYB strut mounts. I still have a ton to get done. I have a 3 point Edelbrock stb and a tds wonderbar to install but I have been holding off on those since I'm planning to put in an LT1 engine which has been delayed due to the wiring issue. I need to get the wiring sent out and converted to a stand alone harness.

I still have my 90 Bird which I am about to scrap out, just need a few more parts from it first.

I need to put a new driverside floorpan into my TA, but not sure how I'm going to do that since the part is in Windsor Canada, which is about 100 miles away, which I cant go to since I cant get across the border. Kinda sucks. Its a pretty big part so its not very feasible to ship it. I'll probably just end up welding my own sheet metal in like I did on my 90 Bird. I just hate doing that since it always ends up looking like crap.

I'm hoping that I can find a reasonably priced lt1 6 speed trans before I get my LT1 put in. Otherwise I will be stuck using the 5 speed from my 90 Bird which I dont think will last long.

Well, talk to yall later. Going to bed, gotta go to work in the morning. Hopefully I'll make some money. FLAT RATE PAY sucks......

Hey there guy, good to hear from you. I understand about life being busy and I'm sorry to hear about losing the child. My condolesense (spelling?).

Post up when you can, we'll be around to see it

Hiya Frank!!

Stop by when you can, we'll be here:)